Nissan Sentra manuals

Nissan Sentra Service Manual: Rear power window motor

Removal and Installation

REMOVAL

  1. Remove the rear door glass regulator (1). Refer to GW-21, "Removal and Installation"
  2. Remove the screws and the rear power window motor (2).

INSTALLATION


INSTALLATION

Installation is in the reverse order of removal.

Rear regulator
Exploded View Rear door panel Rear door glass regulator motor Rear door glass regulator Rear door glass Rear door glass rubber run Removal and Installation NOTE: RH rear door pane ...

Side window glass
Components Side window glass Spacer Headlining Rear body pillar Rear pillar finisher Rear door weatherstrip Primer area Adhesive 7 mm (0.3 in) 12 mm (0.5 in) Removal a ...

Other materials:

Rear disc brake
Brake Burnishing CAUTION: Burnish contact surfaces between brake pads and disc rotor according to the following procedure after refinishing the disc rotor, replacing brake pads or if a soft pedal occurs at very low mileage. Be careful of vehicle speed. Brakes do not operate firmly/sec ...

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system ...

P0643 Sensor power supply
Description ECM supplies a voltage of 5.0 V to some of the sensors systematically divided into 2 groups, respectively. Accordingly, when a short circuit develops in a sensor power source, a malfunction may occur simultaneously in the sensors belonging to the same group as the shorted-circui ...

© 2014-2026 Copyright b17.nisentra.com