Nissan Sentra manuals

Nissan Sentra Owners Manual: Radio

With the ignition placed in the ACC or ON position, press the PWR (power)/VOL (volume) knob to turn the radio on. If you listen to the radio with the engine not running, the ignition should be placed in the ACC position.

Radio reception is affected by station signal strength, distance from radio transmitter, buildings, bridges, mountains and other external influences.

Intermittent changes in reception quality normally are caused by these external influences.

Using a cellular phone in or near the vehicle may influence radio reception quality.

Radio reception

Your NISSAN radio system is equipped with state-of-the-art electronic circuits to enhance radio reception. These circuits are designed to extend reception range, and to enhance the quality of that reception.

However, there are some general characteristics of both FM and AM radio signals that can affect radio reception quality in a moving vehicle, even when the finest equipment is used. These characteristics are completely normal in a given reception area and do not indicate any malfunction in your NISSAN radio system.

Reception conditions will constantly change because of vehicle movement. Buildings, terrain, signal distance and interference from other vehicles can work against ideal reception. Described below are some of the factors that can affect your radio reception.

Some cellular phones or other devices may cause interference or a buzzing noise to come from the audio system speakers. Storing the device in a different location may reduce or eliminate the noise.

Audio system
...

FM radio reception
Range: FM range is normally limited to 25 – 30 mi (40 – 48 km), with monaural (single channel) FM having slightly more range than stereo FM. External influences may sometimes interfere with FM ...

Other materials:

Removal and installation
A/C SWITCH ASSEMBLY Removal and Installation REMOVAL Remove the CVT shift selector finisher (CVT: RE0F11A). Refer to TM-253, "Removal and Installation". Remove the MT shift selector finisher (6MT: RS6F94R). Refer to TM-22, "Removal and Installation". Remove the A/ ...

Fuel pressure
Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT Turn ignition switch ON. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” using CONSULT Start engine. After engine stalls, crank it two or three times to release ...

System
Tire pressure monitoring system TIRE PRESSURE MONITORING SYSTEM : System Diagram TIRE PRESSURE MONITORING SYSTEM : System Description The BCM has pressure judgment and trouble diagnosis functions. When the BCM detects low inflation pressure or another unusual symptom, the low tire pr ...

© 2014-2026 Copyright b17.nisentra.com