Nissan Sentra Service Manual: Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner"
The supplemental restraint system such as “air bag” and “seat belt pre-tensioner”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is included in the sr and sb section of this service manual.
Warning:
- To avoid rendering the srs inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized nissan/infiniti dealer.
- Improper maintenance, including incorrect removal and installation of the srs, can lead to personal injury caused by unintentional activation of the system. For removal of spiral cable and air bag module, see the sr section.
- Do not use electrical test equipment on any circuit related to the srs unless instructed to in this service manual. Srs wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.
Precautions when using power tools (air or electric) and hammers
Warning:
- When working near the airbag diagnosis sensor unit or other airbag system sensors with the ignition on or engine running, do not use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
- When using air or electric power tools or hammers, always switch the ignition off, disconnect the battery and wait at least three minutes before performing any service.
Horn
...
Wiring diagram
Horn
Wiring diagram
...
Other materials:
General Precautions
Always use a 12 volt battery as power source.
Do not attempt to disconnect battery cables while engine is
running.
Before connecting or disconnecting the ECM harness connector,
turn ignition switch OFF and disconnect negative battery
cable. Failure to do so may damage the ECM because
...
B terminal circuit
Description
“B” terminal circuit supplies power to charge the battery and to operate the
vehicles electrical system.
Diagnosis procedure
Regarding wiring diagram information. Refer to chg-9, "wiring diagram".
1.Check “b” terminal connection
Turn ignition switc ...
P2004 Intake manifold runner control valve
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P2004
TUMBLE CONT/V
(Intake manifold runner control
stuck open bank 1)
The target angle of intake manifold runner
control valve c ...
