Nissan Sentra Service Manual: Parking brake shoe
Adjustment - Drum Brake
If equipped with drum brakes, refer to PB-11, "Inspection and Adjustment".
Adjustment - Disc Brake
-
Adjust parking brake lever stroke. Refer to PB-4, "Inspection and Adjustment".
-
Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions:
-
Drive forward
-
Vehicle speed: Approx. 43 km/h (27 MPH) set (constant and forward)
-
Parking brake operating force: 125 N (12.8 kg-f, 28.1 lb-f) set contact
-
Time: Approx. 8 sec.
CAUTION:
To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after every break-in operation.
-
After the break-in procedure, check parking brake lever stroke.
CAUTION:
If it is out of the specification, adjust again. Refer to PB-4, "Inspection and Adjustment".
Revision:
Parking brake system
Inspection and Adjustment
INSPECTION
Lever Stroke
Operate the parking brake lever with a force of 196 N (20.0
kg-f, 44.1 lb-f). Check that the lever stroke is
within the specified number ...
Other materials:
Accelerator pedal released position
learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor output
signal. It must be performed each
time harness connector of accelerator pedal position sensor ...
Primary speed sensor
Exploded View
Transaxle assembly
O-ring
Primary speed sensor
: Always replace after every
disassembly.
: N m (kg-m, in-lb)
: Genuine NISSAN CVT Fluid NS-3
Removal and Installation
REMOVAL
Disconnect the primary speed sensor connector.
Remove the primary speed sensor.
...
Eps branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the eps control unit for damage,
bend and loose connection (unit
side and connector side).
Is the inspection result norm ...
