Nissan Sentra manuals

Nissan Sentra Service Manual: Accelerator pedal released position learning

Nissan Sentra Service Manual / Engine / Engine control system / Basic inspection / Accelerator pedal released position learning

Description

Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position sensor or ECM is disconnected.

Work Procedure

1.START

  1. Make sure that accelerator pedal is fully released.
  2. Turn ignition switch ON and wait at least 2 seconds.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Turn ignition switch ON and wait at least 2 seconds.
  5. Turn ignition switch OFF and wait at least 10 seconds.

>> END

Vin registration
Description VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced. NOTE: Accurate VIN which is registered in ECM may be required for Inspectio ...

Throttle valve closed position learning
Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must ...

Other materials:

Trunk room lamp
Removal and Installation Warning: Do not touch bulb while it is lit or right after being turned off. Burning may result. Caution: Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb. Release the tab (b) to open the lens. ...

P050A, P050B, P050E Cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P050A, P050B or P050E ...

Manual control
While using the voice recognition system, it is possible to select menu options by using the steering wheel controls instead of speaking voice commands. This can be especially helpful if the noise of driving makes it difficult for the voice recognition system to accurately interpret commands. ...

В© 2014-2026 Copyright b17.nisentra.com