Nissan Sentra Service Manual: P1148 Closed loop control

Nissan Sentra Service Manual / Engine / Engine control system / Dtc/circuit diagnosis / P1148 Closed loop control

DTC Logic

DTC DETECTION LOGIC

NOTE:

DTC P1148 is displayed with DTC for A/F sensor 1.

When the DTC is detected, perform the trouble diagnosis of DTC corresponding to A/F sensor 1.

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detecting condition	Possible cause
P1148	CLOSED LOOP-B1 (CLOSED LOOP-B1)	The closed loop control function does not operate even when vehicle is being driven in the specified condition.	Harness or connectors (A/F sensor 1 circuit is open or shorted.) A/F sensor 1 A/F sensor 1 heater

Diagnosis Procedure

DTC P1148 is displayed with DTC for A/F sensor 1.

When the DTC is detected, perform the trouble diagnosis of DTC corresponding to A/F sensor 1.

Refer to EC-94, "DTC Index".

P1078 EVT Control position sensor

DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P1078 EXH TIM SEN/CIRC-B1 (Exhaust val ...

P117A AIR Fuel ratio

DTC Logic DTC DETECTION LOGIC NOTE: If DTC P117A is displayed with other DTC, first perform the trouble diagnosis for the other DTC. Refer to EC-94, "DTC Index". DTC No. CON ...

Other materials:

Towing recommended by NISSAN
(CVT) Continuously Variable Transmission (M/T) Manual transmission NISSAN recommends that your vehicle be towed with the driving (front) wheels off the ground or place the vehicle on a flat bed truck as illustrated. (CVT) Continuously Variable Transmission (M/T) Manual transm ...

Squeak and rattle trouble diagnoses
Work Flow Customer interview Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the diagnostic worksheet during the interview to document the facts and conditions when the noise occurs and any customer's comments; refer to rf-37, "d ...

Dlc branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side). Is the inspection resul ...