Nissan Sentra Service Manual: P0462, P0463 Fuel level sensor

Nissan Sentra Service Manual / Engine / Engine control system / Dtc/circuit diagnosis / P0462, P0463 Fuel level sensor

DTC Logic

DTC DETECTION LOGIC

NOTE:

If DTC P0462 or P0463 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
If DTC P0462 or P0463 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to EC-350, "DTC Logic".

This diagnosis indicates the former, to detect open or short circuit malfunction.

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detecting condition	Possible cause
P0462	FUEL LEVL SEN/CIRC (Fuel level sensor ″A″ circuit low)	An excessively low voltage from the sensor is sent to ECM.	Harness or connectors (The CAN communication line is open or shorted) Harness or connectors (The sensor circuit is open or shorted) Combination meter Fuel level sensor
P0463	FUEL LEVL SEN/CIRC (Fuel level sensor ″A″ circuit high)	An excessively high voltage from the sensor is sent to ECM.

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is between 11 V and 16 V at ignition switch ON.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

Turn ignition switch ON and wait at least 5 seconds.
Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Proceed to EC-329, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK COMBINATION METER FUNCTION

Refer to MWI-17, "CONSULT Function (METER/M&A)".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-39, "Intermittent Incident".

NO >> Proceed to MWI-58, "Component Function Check".

P0461 Fuel level sensor

DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0461 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. If DTC P0461 is displayed with DTC P0607, first perform the ...

P0500 VSS

EXCEPT FOR M/T MODELS EXCEPT FOR M/T MODELS : Description ECM receives vehicle speed signals from two different paths via CAN communication line: One is from the ABS actuator and electric unit (c ...

Other materials:

Regulatory Information
FCC Regulatory information CAUTION: To maintain compliance with FCC’s RF exposure guidelines, use only the supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations. Operation is subject to the following two cond ...

Loading tips
The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./C.M.V.S.S. certification label. Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR. WARNING Properly secure all cargo with ropes or straps to help prevent it from slid ...

Periodic maintenance
Introduction of periodic maintenance The following tables show the normal maintenance schedule. Depending upon weather and atmospheric conditions, varying road surfaces, individual driving habits and vehicle usage, additional or more frequent maintenance may be required. Periodic maintenan ...