Nissan Sentra Owners Manual: Outside mirrors

Nissan Sentra Owners Manual / Pre-driving checks and adjustments / Mirrors / Outside mirrors

The outside mirror remote control will operate

The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position.

Move the small switch 1 to select the right or left mirror. Adjust each mirror to the desired position using the large switch 2 .

WARNING

Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an accident. Use the inside mirror or glance over your shoulder to properly judge distances to other objects.
Do not adjust the mirrors while driving.

You could lose control of your vehicle and cause an accident.

Manual folding outside mirrors

Pull the outside mirror toward the door to fold it.

Heated mirrors (if so equipped)

Some outside mirrors can be heated to defrost, defog, or de-ice for improved visibility. For additional information, see “Rear window and outside mirror defroster switch” in the “Instruments and controls” section of this manual.

Automatic anti-glare rearview mirror (if so equipped)

The inside mirror is designed so that it automatically dims according to the intensity of the headlights of the vehicle following you. The automatic anti-glare feature is activated when the ign ...

Monitor, climate, audio, phone and voice recognition systems

...

Other materials:

Basic inspection
Diagnosis and repair workflow Work flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). >> GO TO 2 2.CONFIRM THE SYMPTOM Try to ...

Basic inspection
Diagnosis and repair work flow Work flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Find out what the customer's concerns are. >> GO TO 2 2.SYMPTOM CHECK Verify the symptom from the customer's information. >> GO TO 3 3.BASIC INSPECTION Check the operation ...

System description
Component parts Component parts location Instrument lower finisher Eco mode switch The eco mode switch is installed to the instrument lower finisher. When the ECO mode indicator lamp on the combination meter is OFF and the ECO mode switch is pressed, the ECO mode is active and ...