Nissan Sentra Service Manual: The door open warning continues displaying, or does not display
Description
- The door ajar warning is displayed even though all of the doors are closed.
- The door ajar warning is not displayed even though a door is ajar.
Diagnosis procedure
1.Check bcm input signal
Check the bcm input signal. Refer to dlk-102, "component function check" (with intelligent key) or dlk- 253, "component function check" (without intelligent key).
Is the inspection result normal? Yes >> go to 2.
No >> go to 3.
2.Check combination meter input signal
Select the METER/M&A Data Monitor and check the DOOR W/L monitor value while opening and closing doors.
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".
NO >> Replace BCM. Refer to BCS-73, "Removal and Installation" (with Intelligent Key) or BCS-126, "Removal and Installation" (without Intelligent Key).
3.Check door switch signal circuit
Check the door switch signal circuit. Refer to dlk-102, "diagnosis procedure" (with intelligent key) or dlk- 253, "diagnosis procedure" (without intelligent key).
Is the inspection result normal? Yes >> go to 4.
No >> repair or replace harness or connector.
4.Check door switch
Perform a unit check for the door switch. Refer to DLK-103, "Component Inspection" (with Intelligent Key) or DLK-255, "Component Inspection" (without Intelligent Key).
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".
NO >> Replace applicable door switch. Refer to DLK-194, "Removal and Installation" (with Intelligent Key) or DLK-341, "Removal and Installation" (without Intelligent Key).
The oil pressure warning lamp does not turn off
Description
The oil pressure warning lamp remains illuminated while the engine is running
(normal oil pressure).
Diagnosis procedure
1.Check combination meter input signal
Start the engine a ...
The parking brake release warning continues displaying, or does not display
Description
The parking brake warning is displayed while driving the vehicle even
though the parking brake is released.
The parking brake warning is not displayed while driving the vehicle
...
Other materials:
Rear disc brake
Brake Burnishing
CAUTION:
Burnish contact surfaces between brake pads and disc rotor
according to the following procedure
after refinishing the disc rotor, replacing brake pads or if a soft pedal
occurs at very low mileage.
Be careful of vehicle speed. Brakes do not operate firmly/sec ...
C1115 ABS Sensor [abnormal signal]
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1115
ABS SENSOR
[ABNORMAL SIGNAL]
When difference in wheel speed between any wheel
and others is detected while the vehicle is driven, because
of installation of t ...
Dtc/circuit diagnosis
U1000 can comm circuit
Description
Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description".
Dtc logic
DTC DETECTION LOGIC
NOTE:
U1000 can be set if a module harness was disconnected and reconnected,
perhaps during a repair. Confirm
that there are actual CAN diagnostic sym ...
