Nissan Sentra manuals

Nissan Sentra Service Manual: On board diagnostic (OBD) system

Nissan Sentra Service Manual / Engine / Engine control system / Operation / On board diagnostic (OBD) system

Diagnosis Description

This system is an on board diagnostic system that records exhaust emission-related diagnostic information and detects a sensors/actuator-related malfunction. A malfunction is indicated by the malfunction indicator lamp (MIL) and stored in ECU memory as a DTC. The diagnostic information can be obtained with the diagnostic tool (GST: Generic Scan Tool).

GST (Generic Scan Tool)

When GST is connected with a data link connector equipped on the vehicle side, it will communicate with the control unit equipped in the vehicle and then enable various kinds of diagnostic tests. Refer to GI-47, "Description".

NOTE:

Service $0A is not applied for regions where it is not mandated.

Automatic speed control device  (ASCD)
AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Switch Name and Function SWITCHES AND INDICATORS CRUISE indicator SET indicator* CANCEL switch ACCEL/RES switch COAST/SET switch ASCD MAIN sw ...

Diagnosis system (ECM)
Diagnosis description : 1st trip detection logic and two trip detection logic When a malfunction is detected for the first time, 1st trip DTC and 1st trip Freeze Frame data are stored in the ECM ...

Other materials:

Plug
Description Replace the O-ring if oil leakage or exudes from the plug. Exploded View Plug O-ring O-ring Plug : Always replace after every disassembly. : NВ·m (kg-m, ft-lb) : NВ·m (kg-m, in-lb) : Genuine NISSAN CVT Fluid NS-3 Removal and Installation NOTE: Replace ...

P0078 EVT Control solenoid valve
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0078 EX V/T ACT/CIRC-B1 (Exhaust valve control solenoid circuit bank 1) An improper voltage is sent to the ECM through exhaust v ...

Ipdm-e branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the IPDM E/R for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? Yes ...

© 2014-2026 Copyright b17.nisentra.com