Component Function Check
1.CHECK MIL FUNCTION
Is the inspection result normal? YES >> INSPECTION END
NO >> Proceed to EC-467, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC WITH ECM
Check that DTC UXXXX is not displayed.
Is the inspection result normal? YES >> GO TO 2.
NO >> Perform trouble diagnosis for DTC UXXXX. Refer to EC-94, "DTC Index".
2.CHECK DTC WITH COMBINATION METER
Check DTC with combination meter. Refer to MWI-17, "CONSULT Function (METER/M&A)".
Is the inspection result normal? YES >> GO TO 3.
NO >> Perform trouble diagnosis for DTC indicated. Refer to MWI-26, "DTC Index".
3.CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to GI-39, "Intermittent Incident".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".
NO >> Repair or replace error-detected parts.
Refrigerant pressure sensor
On board refueling vapor recovery(ORVR)U1000 CAN Comm circuit
Description
Can (controller area network) is a serial communication line for
real time application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped onto a vehicle, and each co ...
Service data and specifications (SDS)
Idle speed
*: Under the following conditions
A/C switch: OFF
Electric load: OFF (Lights, heater fan & rear window defogger)
Steering wheel: Kept in straight-ahead position
Ignition timing
*: Under the following conditions
A/C switch: OFF
Electric load: OFF (Lights, hea ...
Door handle
Front door handle
Front door handle : exploded view
Outside handle bracket
Rear gasket
Front gasket
Outside handle escutcheon
Outside handle
Door key cylinder rod
Inside handle assembly
Front door handle : removal and installation
- inside handle
REMOVAL
Remove fr ...