Nissan Sentra manuals

Nissan Sentra Owners Manual: If your vehicle overheats

Nissan Sentra Owners Manual / In case of emergency / If your vehicle overheats

If your vehicle is overheating (indicated by an extremely high temperature gauge reading), or if you feel a lack of engine power, detect abnormal noise, etc., take the following steps.

WARNING

  • Do not continue to drive if your vehicle overheats. Doing so could cause engine damage or a vehicle fire.

  • To avoid the danger of being scalded, never remove the radiator cap while the engine is still hot. When the radiator cap is removed, pressurized hot water will spurt out, possibly causing serious injury.

  • Do not open the hood if steam is coming out.
  1. Move the vehicle safely off the road, apply the parking brake and move the shift lever to N (Neutral) (manual transmission) or to P (Park) (CVT).

Do not stop the engine.

  1. Turn off the air conditioner (if so equipped).

    Open all the windows, move the heater or air conditioner temperature control to maximum hot and fan control to high speed.

  2. Get out of the vehicle. Look and listen for steam or coolant escaping from the radiator before opening the hood. (If steam or coolant is escaping, turn off the engine.) Do not open the hood further until no steam or coolant can be seen.
  3. Open the engine hood.
WARNING

If steam or water is coming from the engine, stand clear to prevent getting burned.
  1. Visually check drive belts for damage or looseness. Also check if the cooling fan is running. The radiator hoses and radiator should not leak water. If coolant is leaking, the water pump belt is missing or loose, or the cooling fan does not run, stop the engine.
WARNING

Be careful not to allow your hands, hair, jewelry or clothing to come into contact with, or get caught in, engine belts or the engine cooling fan. The engine cooling fan can start at any time.
  1. After the engine cools down, check the coolant level in the engine coolant reservoir with the engine running. Add coolant to the engine coolant reservoir if necessary. Have your vehicle repaired at a NISSAN dealer.
Push starting
CAUTION Do not push start this vehicle. The three-way catalyst may be damaged. Continuously Variable Transmission (CVT) models and Manual Transmission (MT) cannot be push-started or towsta ...

Towing your vehicle
When towing your vehicle, all State (Provincial in Canada) and local regulations for towing must be followed. Incorrect towing equipment could damage your vehicle. Towing instructions are available ...

Other materials:

Precaution for Liquid Gasket
Removal of liquid gasket After removing the bolts and nuts, separate the mating surface and remove the old liquid gasket using tool. Tool number : kv10111100 (j-37228) Caution: Do not damage the mating surfaces. Tap the seal cutter to insert it (1). In areas where the tool is diffic ...

Condenser
Removal and installation Removal Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FINISHER : Removal and Installation". Disconnect the harness connectors (1), remove the condenser bolt (A) and the condenser (2). : Front Installation Installation is in th ...

Map lamp
Removal and installation Removal Lower front edge of map lamp (1) down from the headlining by releasing the metal clips, then slide forward to clear pawls at rear. : Metal clip Pawl Disconnect the harness connectors from the map lamp and remove. Installation Installation is in t ...

В© 2014-2026 Copyright b17.nisentra.com