Nissan Sentra Owners Manual: Precautions on cruise control

Nissan Sentra Owners Manual / Starting and driving / Cruise control (if so equipped) / Precautions on cruise control

ACCEL/RES switch
COAST/SET switch
CANCEL switch
ON·OFF switch

If the cruise control system malfunctions, it cancels automatically. The CRUISE indicator light in the instrument panel then blinks to warn the driver, see “Warnings/Indicator Lights and Audible Reminders” in the “Instruments and controls” section.
If the CRUISE indicator light blinks, push the cruise control ON·OFF switch off and have the system checked by a NISSAN dealer.
The CRUISE indicator light may blink when the cruise control ON·OFF switch is pushed ON while pushing the ACCEL/RES, COAST/SET, or CANCEL switch. To properly set the cruise control system, use the following procedures.

WARNING

Do not use the cruise control when driving under the following conditions:

When it is not possible to keep the vehicle at a set speed.
In heavy traffic or in traffic that varies in speed.
On winding or hilly roads.
On slippery roads (rain, snow, ice, etc.).
In very windy areas.

Doing so could cause a loss of vehicle control and result in an accident.

Cruise control (if so equipped)

...

Cruise control operations

The cruise control allows driving at a speed between 25 - 89 MPH (40 - 144 km/h) without keeping your foot on the accelerator pedal. To turn on the cruise control, push the ON·OFF switch. The C ...

Other materials:

Removal and installation
Audio unit Exploded view Audio unit Audio unit bracket (LH) Audio unit bracket (RH) Removal and installation Removal Disconnect the negative battery terminal. Refer to pg-50, "removal and installation (battery)". Remove cluster lid c lower. Refer to ip-20, "re ...

List of voice commands
Main Menu “Call” “Phonebook” “Recent Calls” “Connect Phone” When you press and release the button on the steering wheel, you can choose from the commands on the Main Menu. The following pages describe these commands and the commands in each sub-menu. Remember to wai ...

Wiper blade
Wiper blade WIPER BLADE : Removal and Installation REMOVAL Put the wiper arms in the service position. Turn the ignition switch ON and then OFF. Within 1 minute, activate washer switch 2 times in less than 0.5 seconds to put the wiper arms in the service position. Lift the w ...