Nissan Sentra Owners Manual: Towing your vehicle

Nissan Sentra Owners Manual / In case of emergency / Towing your vehicle

When towing your vehicle, all State (Provincial in Canada) and local regulations for towing must be followed. Incorrect towing equipment could damage your vehicle. Towing instructions are available from a NISSAN dealer. Local service operators are generally familiar with the applicable laws and procedures for towing. To assure proper towing and to prevent accidental damage to your vehicle, NISSAN recommends having a service operator tow your vehicle. It is advisable to have the service operator carefully read the following precautions:

WARNING

Never ride in a vehicle that is being towed.
Never get under your vehicle after it has been lifted by a tow truck.

CAUTION

When towing, make sure that the transmission, axles, steering system and powertrain are in working condition. If any of these conditions apply, dollies or a flatbed tow truck must be used.
Always attach safety chains before towing.

For information about towing your vehicle behind a recreational vehicle (RV), refer to “Flat towing” in the “Starting and Driving” section of this manual.

If your vehicle overheats

If your vehicle is overheating (indicated by an extremely high temperature gauge reading), or if you feel a lack of engine power, detect abnormal noise, etc., take the following steps. WARN ...

Towing recommended by NISSAN

(CVT) Continuously Variable Transmission (M/T) Manual transmission NISSAN recommends that your vehicle be towed with the driving (front) wheels off the ground or place the vehicle on a f ...

Other materials:

Ground
Ground distribution Main harness Engine room harness Engine control harness Body harness ...

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The supplemental restraint system such as вЂњair bagвЂќ and вЂњseat belt pre-tensionerвЂќ, used along with a front seat belt, helps to reduce the risk or severity of injur ...

Precaution
Precautions for Trouble Diagnosis Caution: Follow the instructions listed below. Failure to do this may cause damage to parts: Never apply 7.0 V or more to the measurement terminal. Use a tester with open terminal voltage of 7.0 V or less. Turn the ignition switch off and disconnect the ...