Nissan Sentra Service Manual: Hvac branch line circuit
Diagnosis procedure
1.Check connector
- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal
- Check the terminals and connectors of the a/c auto amp. For damage, bend and loose connection (unit side and connector side).
Is the inspection result normal? Yes >> go to 2.
No >> repair the terminal and connector.
2.Check harness for open circuit
- Disconnect the connector of a/c auto amp.
- Check the resistance between the a/c auto amp. Harness connector terminals.
Is the measurement value within the specification? Yes >> go to 3.
No >> repair the a/c auto amp. Branch line.
3.Check power supply and ground circuit
Check the power supply and the ground circuit of the a/c auto amp. Refer to hac-83, "a/c auto amp. : Diagnosis procedure".
Is the inspection result normal? Yes (present error)>>replace the a/c auto amp. Refer to hac-105, "removal and installation".
Yes (past error)>>error was detected in the a/c auto amp. Branch line.
No >> repair the power supply and the ground circuit.
Strg branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor fo ...
BCM branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the bcm for damage, bend and ...
Other materials:
Does not stop fully-open or fullyclosed
position
Diagnosis procedure
1. Perform initialization procedure
Perform initialization procedure.
Refer to RF-18, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair
Requirement".
Is the inspection result normal?
YES >> Inspection End.
NO >> Perform basic ins ...
Dtc/circuit diagnosis
U1000 can comm circuit
DTC Logic
DTC DETECTION LOGIC
CONSULT Display
DTC Detection Condition
Possible Cause
CAN COMM CIRCUIT
[U1000]
AV control unit is not transmitting or receiving
CAN communication signal for 2 seconds or
more.
CAN communication system.
...
Dtc/circuit diagnosis
U1000 can comm circuit
Description
Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description".
Dtc logic
Dtc detection logic
Consult display
Dtc detection condition
Possible cause
Can comm circuit
[u1000]
When ipdm e/r cannot communicate with can comm ...
