Nissan Sentra manuals

Nissan Sentra Service Manual: Does not stop fully-open or fullyclosed position

Diagnosis procedure

1. Perform initialization procedure

Perform initialization procedure.

Refer to RF-18, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> Inspection End.

NO >> Perform basic inspection. Refer to RF-16, "Work Flow".

Retained power operation does not operate properly

Diagnosis procedure

1.Check front door switch

Check front door switch.

Refer to dlk-102, "component function check".

Is the inspection result normal? Yes >> check intermittent incident. Refer to gi-39, "intermittent incident".

No >> repair or replace malfunctioning parts.

Moonroof does not operate antipinch function
Diagnosis Procedure 1. Perform initialization procedure Perform initialization procedure. Refer to rf-18, "additional service when replacing control unit : special repair requirement" ...

Squeak and rattle trouble diagnoses
Work Flow Customer interview Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the diagnostic worksheet during the interview to document th ...

Other materials:

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system ...

Measurement of weights
Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determine axle loads. Individual axle loads should not exceed either of the gross axle weight ratings ( ...

P0711 Transmission fluid temperature sensor A
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0711 FLUID TEMP SENSOR A (Transmission Fluid Temperature Sensor A Circuit Range/ Performance) When any of 1 or 2 is satisfied: ...

© 2014-2026 Copyright b17.nisentra.com