Nissan Sentra Service Manual: Front door finisher
Exploded View
- Front door panel
- Front door finisher
- Inside door handle escutcheon
- Main power window and door lock/ unlock switch finisher
- Door mirror corner finisher
- Grommet
Clip
Pawl
Front
NOTE:
LH side shown; RH similar.
Removal and Installation
CAUTION:
- When removing, always use a suitable tool that is made of plastic to prevent damage to the parts.
- Do not damage the door panel.
REMOVAL
- Remove door mirror corner finisher (1) according to numerical order of arrows as shown.
- Remove inside door handle escutcheon.
- Apply protective tape (A) to protect the component from damage as shown.
- Insert a suitable tool (A) as shown between inside door handle escutcheon and inside door handle.
- With suitable tool (A) in position, insert a second suitable tool (B) as shown, then release pawl.
Pawl
- Pull upward on the inside door handle escutcheon as shown to release the pawls on the upper portion of inside door handle escutcheon.
Pawl
- Press down on the inside door handle escutcheon as shown to release the pawls on the lower portion of inside door handle escutcheon.
Pawl
- Insert a suitable tool (A) as shown to release the remaining pawl and remove.
Pawl
- Remove the main power window and door lock/unlock switch (LH). Refer to PWC-70, "Removal and Installation".
- Remove the main power window and door lock/unlock switch (RH). Refer to PWC-71, "Removal and Installation".
- Remove front door finisher.
- Remove front door finisher screw (A).
- Apply protective tape (A) to protect the component from damage as shown.
- Release front door finisher clips using a suitable tool (A) as shown.
Clip
- Remove front door finisher as shown.
INSTALLATION
Installation is in the reverse order of removal
CAUTION:
When installing, check that clips are accurately aligned with the holes on the door panel, then press in.
Rear door finisher
Exploded View
Rear door panel
Rear door finisher
Inside door handle escutcheon
Rear power window switch finisher
Grommet
Clip
Pawl
Front
Removal and Installation
CAUTION: ...
Other materials:
Performance test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFC-134a) or
manifold gauge.
Start the engine, and set to the following condition.
Test condition
Maintain test condition until A/C system becomes stable. (Approximately
10 minutes)
Check t ...
Heater operation
This mode is used to direct heated air to the foot
outlets. Some air also flows from the defrost
outlets and the side vent outlets.
Press the button to the OFF
position
for normal heating.
Press the air flow control
button.
Turn the fan control dial to the desired position.
Tur ...
Symptom diagnosis
The eco mode indicator lamp does not turn on
Description
The ECO mode indicator lamp does not turn ON when the ECO mode switch is
operated.
Diagnosis Procedure
1.Perform combination meter on board diagnosis
Perform combination meter on board diagnosis. Refer to MWI-16, "Description" ...
