Nissan Sentra Service Manual: DTC/Circuit diagnosis
POSITION SWITCH
BACK-UP LAMP SWITCH
BACK-UP LAMP SWITCH : Component Inspection
1.CHECK BACK-UP LAMP SWITCH
- Disconnect position switch harness connector. Refer to TM-21, "Removal and Installation".
- Check continuity between position switch terminals.
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace position switch. Refer to TM-21, "Removal and Installation".
PARK/NEUTRAL POSITION (PNP) SWITCH
Park/neutral position (PNP) Switch :Component Inspection
1.CHECK PARK/NEUTRAL POSITION (PNP) SWITCH
- Disconnect position switch harness connector. Refer to TM-21, "Removal and Installation".
- Check continuity between position switch terminals.
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace position switch. Refer to TM-21, "Removal and Installation".
System description
COMPONENT PARTS
Component Parts Location
Transaxle assembly
STRUCTURE AND OPERATION
Sectional View
3rd input gear
3rd-4th synchronizer hub assembly
4th input gear
5th ...
Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. The numbers indicate
the order of the inspection. If necessary ...
Other materials:
Wiring diagram
Intelligent key system/engine start function
Wiring diagram
Nissan vehicle immobilizer systemnats
Wiring Diagram
Vehicle security system
Wiring diagram
...
Unit disassembly and assembly
Steering gear and linkage
Exploded View
Outer socket
Boot clamp (small diameter)
Boot
Boot clamp (large diameter)
Inner socket
Gear housing assembly
Disassembly and Assembly
DISASSEMBLY
Loosen outer socket lock nut, and remove outer socket.
CAUT ...
Removal and installation
Hood
Hood assembly
Hood assembly : exploded view
Hood hinge (LH/RH)
Hood assembly
Hood bumper rubber
Hood seal
Hood insulator
Hood support rod
Hood support rod clamp
Clip
Hood assembly : removal and installation
CAUTION:
Use two people when removing or installing h ...
