Nissan Sentra Service Manual: Consult checking system

Circuit Inspection

DESCRIPTION In general, testing electrical circuits is an easy task if it is approached in a logical and organized method. Before beginning it is important to have all available information ...

Description

NOTE: This vehicle is diagnosed using the CONSULT-III plus. When CONSULT is connected with a data link connector equipped on the vehicle side, it will communicate with the control unit equipp ...

Other materials:

Precautions for Suspension
When installing rubber bushings, the final tightening must be carried out under unladen conditions with tires on ground. Spilled oil might shorten the life of rubber bushings. Be sure to wipe off any spilled oil. Unladen conditions mean that fuel, engine coolant and lubricant are ...

General Precautions
Always use a 12 volt battery as power source. Do not attempt to disconnect battery cables while engine is running. Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF and disconnect negative battery cable. Failure to do so may damage the ECM because ...

P1652 Starter motor system comm
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. ECM transmits a control signal to IPDM E/R via BCM by CAN communication. Under normal conditions, ECM controls and maintains the starter relay in OFF state during following condition: ...