Nissan Sentra Service Manual: Parking, license plate and tail lamps are not turned on

Nissan Sentra Service Manual / Driver controls / Exterior lighting system / Symptom diagnosis / Parking, license plate and tail lamps are not turned on

Description

The parking, license plate and tail lamps do not turn on in with any lighting switch setting.

Diagnosis procedure

1.Combination switch (lighting and turn signal switch) inspection

Check the combination switch (lighting and turn signal switch). Refer to BCS-72, "Symptom Table" (with Intelligent Key system) or BCS-125, "Symptom Table" (without Intelligent Key system).

Is the inspection results normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning part.

2.Check tail lamp relay request signal input

Consult data monitor

Select TAIL & CLR REQ of IPDM E/R DATA MONITOR item.
While operating the lighting switch, check the monitor status.

Is the inspection results normal?

Is the inspection results normal? YES >> GO TO 3

No >> replace bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs- 126, "removal and installation" (without intelligent key system).

3.Park lamp circuit inspection

Check the parking lamp circuit. Refer to exl-96, "diagnosis procedure".

Is the inspection results normal? Yes >> replace ipdm e/r. Refer to pcs-30, "removal and installation" (with intelligent key system) or pcs-58, "removal and installation" (without intelligent key system).

No >> repair or replace the malfunctioning part.

Both side headlamps (lo) are not turned on

Description The headlamps (both sides) do not turn on in any lighting switch setting. Diagnosis Procedure 1.Check combination switch (lighting and turn signal switch) Check the combination switc ...

Both side front fog lamps are not turned on

Description The front fog lamps do not turn on in any setting. Diagnosis procedure 1.Combination switch (lighting and turn signal switch) inspection Check the combination switch (lighting and turn ...

Other materials:

Ipdm-e branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the ipdm e/r for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? Yes ...

C1113, C1145, C1146 Yaw rate/side/decel G Sensor
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1113 G SENSOR When a malfunction is detected in longitunal G sensor signal. ABS actuator and electric unit (control unit) C1145 YAW RATE ...

Symptom diagnosis
Engine does not start when intelligent key is inside of vehicle Description Engine does not start when push-button ignition switch is pressed while carrying intelligent key. Note: Check that vehicle is under the condition shown in вЂњconditions of vehicleвЂќ before starting diagnos ...