Nissan Sentra Service Manual: Av branch line circuit
Diagnosis Procedure
1.Check connector
- Turn the ignition switch off.
- Disconnect the battery cable from the negative terminal.
- Check the terminals and connectors of the av control unit for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal? Yes >> go to 2.
No >> repair the terminal and connector.
2.Check harness for open circuit
- Disconnect the connector of av control unit.
- Check the resistance between the av control unit harness connector terminals.
- With navigation system without BOSE audio system
- With navigation system and bose audio system
Is the measurement value within the specification? Yes >> go to 3.
No >> repair the av control unit branch line.
3.Check power supply and ground circuit
Check the power supply and the ground circuit of the av control unit. Refer to the following.
- With navigation system without bose audio system: refer to av-270, "av control unit : diagnosis procedure".
- With navigation system and bose audio system: refer to av-370, "av control unit : diagnosis procedure".
Is the inspection result normal? Yes (present error)>>replace the av control unit. Refer to the following.
- With navigation system without bose audio system: refer to av-298, "removal and installation".
- With navigation system and bose audio system: refer to av-406, "removal and installation".
Yes (past error)>>error was detected in the av control unit branch line.
No >> repair the power supply and the ground circuit.
Strg branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor fo ...
Hvac branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the a/c auto amp. For damage ...
Other materials:
Engine oil
Inspection
Engine oil level
Note:
Before starting engine, put vehicle horizontally and check the engine oil
level. If engine is already started, stop
it and allow 10 minutes before checking.
Pull out oil level gauge and wipe it clean.
Insert oil level gauge and check that the engine oil ...
Dlc branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the data link connector for
damage, bend and loose connection
(connector side and harness side).
Is the inspection resul ...
How to use the touch-screen
CAUTION
The glass display screen may break if it
is hit with a hard or sharp object. If the
glass screen breaks, do not touch it.
Doing so could result in an injury.
To clean the display, never use a rough
cloth, alcohol, benzine, thinner or any
kind of solvent or paper towel with a
chemic ...
