Nissan Sentra Service Manual: Hvac branch line circuit
Diagnosis procedure
1.Check connector
- Turn the ignition switch off.
- Disconnect the battery cable from the negative terminal.
- Check the terminals and connectors of the a/c auto amp. For damage, bend and loose connection (unit side and connector side).
Is the inspection result normal? Yes >> go to 2.
No >> repair the terminal and connector.
2.Check harness for open circuit
- Disconnect the connector of A/C auto amp.
- Check the resistance between the a/c auto amp. Harness connector terminals.
Is the measurement value within the specification? Yes >> go to 3.
No >> repair the a/c auto amp. Branch line.
3.Check power supply and ground circuit
Check the power supply and the ground circuit of the a/c auto amp. Refer to hac-83, "a/c auto amp. : Diagnosis procedure".
Is the inspection result normal? Yes (present error)>>replace the a/c auto amp. Refer to hac-105, "removal and installation".
Yes (past error)>>error was detected in the a/c auto amp. Branch line.
No >> repair the power supply and the ground circuit.
Av branch line circuit
Diagnosis Procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the av control unit for dama ...
BCM branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the bcm for damage, bend and ...
Other materials:
Wiring diagram
Tire pressure monitoring system
With intelligent key
WITH INTELLIGENT KEY : Wiring Diagram
Without intelligent key
WITHOUT INTELLIGENT KEY : Wiring Diagram
...
Interior room lamp control circuit
Description
Controls each interior room lamp (ground side) by pwm signal.
Note:
Pwm signal control period is approximately 250 hz (in the gradual
brightening/dimming).
Component function check
Caution:
Before performing the diagnosis, check that the following are normal.
Interior room l ...
System description
Component parts
Component parts location
Instrument lower finisher
Component description
Sport mode switch
The sport mode switch is installed to the instrument lower finisher.
When the sport mode indicator lamp on the combination meter
is off and the sport mode switch is pres ...
