Description

Diagnosis procedure
1. Check fuses
Check that the following fuses are not blown.

Is the fuse blown? Yes >> replace the blown fuse after repairing the affected circuit.
No >> inspection end.
Front wiper motor lo circuitP2100, P2103 Throttle control motorrelay
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P2100
ETC MOT PWR-B1
(Throttle actuator “A”
control motor circuit/
open)
ECM detects a voltage of power source for
t ...
Parking lamp circuit
Description
The ipdm e/r (intelligent power distribution module engine room) controls the
tail lamp relay based on inputs
from the bcm over the can communication lines. When the tail lamp relay is
energized, power flows through
fuse 36, located in the ipdm e/r. Power then flows to the front ...
Harness connector
Description
Harness connector (tab-locking type)
The tab-locking type connectors help prevent accidental looseness or
disconnection.
The tab-locking type connectors are disconnected by pushing or lifting
the locking tab(s). Refer to the figure
below.
Refer to the next page for desc ...