Nissan Sentra Service Manual: Front wiper motor lo circuit
Component function check
1. Check front wiper lo operation
Ipdm e/r auto active test
- Start ipdm e/r auto active test. Refer to pcs-9, "diagnosis description" (with intelligent key system) or pcs-37, "diagnosis description" (without intelligent key system).
- Check that the front wiper operates at the lo operation.
Consult active test
- Select FRONT WIPER of IPDM E/R active test item.
- While operating the test item, check that front wiper lo operation and off.
Lo : front wiper lo operation
Off : stop the front wiper.
Is the inspection result normal? Yes >> front wiper motor lo circuit is normal.
No >> refer to ww-37, "diagnosis procedure".
Diagnosis procedure
Regarding Wiring Diagram information, refer to WW-24, "Wiring Diagram - With Intelligent Key" or WW-29, "Wiring Diagram - Without Intelligent Key".
1. Check front wiper motor (lo) input voltage
Consult active test
- Turn the ignition switch OFF.
- Disconnect front wiper motor.
- Turn the ignition switch on.
- Select front wiper of ipdm e/r active test item.
- While operating the test item, check voltage between IPDM E/R harness connector E45 and ground.
Is the inspection result normal? YES >> GO TO 2.
NO >> Replace IPDM E/R. Refer to PCS-30, "Removal and Installation" (with Intelligent Key system) or PCS-58, "Removal and Installation" (without Intelligent Key system).
2. Check front wiper motor (lo) open circuit
- Turn the ignition switch OFF.
- Disconnect ipdm e/r.
- Check continuity between ipdm e/r harness connector e45 and front wiper motor harness connector e1.
Is the inspection result normal?
Yes >> go to 3.
No >> repair or replace the harness or connectors.
3. Check front wiper motor (lo) short circuit
Check continuity between IPDM E/R harness connector E45 and ground.
Is the inspection result normal? YES >> Repair or replace the harness or connectors.
NO >> Replace front wiper motor. Refer to WW-62, "Removal and Installation".
Wiper and washer fuse
Description
Diagnosis procedure
1. Check fuses
Check that the following fuses are not blown.
Is the fuse blown?
Yes >> replace the blown fuse after repairing the affected circuit.
...
Front wiper motor hi circuit
Component function check
1. Check front wiper hi operation
Ipdm e/r auto active test
Start ipdm e/r auto active test. Refer to ww-15, "diagnosis description"
(with intelligent key ...
Other materials:
P0963 Pressure control solenoid A
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0963
PC SOLENOID A
(Pressure Control Solenoid A
Control Circuit High)
The line pressure solenoid valve current is 200
mA or less c ...
Seat belt buckle switch signal circuit
Description
Transmits a seat belt buckle switch lh (driver seat) signal to the
combination meter
Component function check
1. Check combination meter input signal
Select data monitor for meter/m&a and check the buckle sw monitor value.
YES >> Inspection End.
NO >> Refe ...
U1000 CAN Comm circuit
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
U1000
CAN COMM CIRCUIT
When CAN communication signal is not continuously
received for 2 seconds or more
CAN communication system malfunction
Diagnosis Procedure
...
