To help prevent the vehicle from moving unexpectedly by erroneous operation of the Intelligent Key or to help prevent the vehicle from being stolen, a chime or buzzer sounds from inside and outside the vehicle and a warning light comes on in the instrument panel.
When a chime or beep sounds or the warning light comes on, be sure to check the vehicle and the Intelligent Key.
Audible reminder and warning when locking the doors
When the chime or buzzer sounds from inside and outside the vehicle, check for the following:
Audible reminder and warning when the engine stops
When the P position selecting warning light
(
) in the instrument panel
blinks in red:
When the chime sounds intermittently:
If the chime sounds continuously when the driver’s door is opened, check the following:
Alarm and warning when the engine starts
When the Intelligent Key system warning light
(
) blinks red and the outside
buzzer
sounds, make sure the Intelligent Key is inside the
vehicle.
Warning for low battery power
When the Intelligent Key battery is low, the Intelligent
Key system warning light (
) will
blink
green for about 30 seconds after the ignition
switch is placed in the ON position. This warning
is to let you know that the battery of the Intelligent
Key will run down soon. Replace it with a new
one. Refer to “Battery replacement” in the “Maintenance
and do-it-yourself” section.
NISSAN recommends replacing the battery at a NISSAN dealer.
Preventing the Intelligent Key from being left in the vehicle
If you lock all doors using the power door lock switch with the Intelligent Key in the vehicle, all of the doors unlock immediately and the buzzer will warn you when the door is closed.
Warning lights and audible reminders
Troubleshooting guideAir cleaner filter
Exploded View
Mass air flow sensor
Mass air flow gasket
Clamp
Air duct (suction side)
Resonator
Clamp
PCV hose
Clamp
Clamp
Air cleaner cover
Mounting rubber
Air cleaner filter
Air cleaner body
Air duct inlet (lower)
Air duct inlet (upper)
Grommet
Bracket
Gro ...
Eps branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the eps control unit for damage,
bend and loose connection (unit
side and connector side).
Is the inspection result norm ...
ECU diagnosis information
A/C AUTO AMP
Reference Value
VALUES ON THE DIAGNOSIS TOOL
TERMINAL LAYOUT
PHYSICAL VALUES
DTC Inspection Priority Chart
If some DTCs are displayed at the same time, perform inspections one by one
based on the following priority
chart.
DTC Index
*: Perform self ...