Nissan Sentra Owners Manual: Warning/indicator lights
| Warning light | Name |
 |
Anti-lock Braking System (ABS) warning light |
 |
Brake warning light |
 |
Charge warning light |
 |
Door open warning light |
 |
Engine oil pressure warning light |
 |
Low fuel warning light |
 |
Low tire pressure warning light |
 |
Low windshieldwasher fluid warning light |
 |
NISSAN Intelligent Key® lock warning light (M/T models) (if so equipped) |
 |
NISSAN Intelligent Key® warning light (if so equipped) |
 |
P position selecting warning light (CVT models) (if so equipped) |
 |
Power steering warning light |
 |
Seat belt warning light |
 |
Supplemental air bag warning light |
| Indicator light | Name |
 |
Continuously Variable Transmission (CVT) position indicator light (CVT models) |
 |
Cruise main switch indicator light (if so equipped) |
 |
ECO mode indicator light |
 |
Engine start operation indicator light (if so equipped) |
 |
Front fog light indicator light (if so equipped) |
 |
Front passenger air bag status light |
 |
High beam indicator light (blue) |
 |
Malfunction Indicator Light (MIL) |
 |
Overdrive off indicator light (CVT models) |
 |
Security indicator light |
 |
Side light and headlight indicator light (green) |
 |
Slip indicator light |
 |
SPORT mode indicator light |
 |
Turn signal/hazard indicator lights |
 |
Vehicle Dynamic Control (VDC) off indicator light |
Engine compartment check locations
MRA8DE engine
Engine oil filler cap
Brake and clutch (if so equipped) fluid
reservoir
Air cleaner
Battery
Fuse/fusible link box
Engine coolant reservoir
Radiator cap
Engine o ...
Other materials:
C1708, C1709, C1710, C1711 Transmitter (no data)
DTC Logic
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS transmitter IDs
Display tire pressure reported by the TPMS transmitter
Read TPMS DTCs
Registe ...
M&a branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the combination meter for damage,
bend and loose connection
(unit side and connector side).
Is the inspection result nor ...
Basic inspection
Diagnosis and repair workflow
Workflow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW CUSTOMER
Interview the customer to obtain as much information as possible about the
conditions and environment under
which the malfunction occurred.
>> GO TO 2.
2.SYMPTOM CHECK
Verify symptoms.
...
