Nissan Sentra Service Manual: VDC off switch
Removal and Installation
REMOVAL
-
Remove the instrument lower panel LH. Refer to IP-21, "Removal and Installation".
-
Remove the switch plate screws and remove the switch plate.
-
Release pawls using suitable tool and remove the VDC OFF switch.
INSTALLATION
Installation is in the reverse order of removal.
Abs actuator and electric unit (control unit)
Exploded View
ABS actuator and electric unit (control
unit)
ABS actuator and electric unit (control
unit) harness connector
Bushing
Bracket
To master cylinder s ...
Steering angle sensor
Exploded View
Steering angle sensor
Screw
Front
Removal and Installation
REMOVAL
Remove spiral cable assembly. Refer to SR-16, "Removal and
Installation". ...
Other materials:
P0447 EVAP Canister vent control valve
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0447
VENT CONTROL VALVE
(Evaporative emission system vent
control circuit open)
An improper voltage signal is sent to
ECM throug ...
A-bag branch line circuit
Diagnosis procedure
Warning:
Always observe the following items for preventing accidental
activation.
Before servicing, turn ignition switch off, disconnect battery
negative terminal, and wait 3 minutes
or more. (To discharge backup capacitor.)
Never use unspecified tester or other ...
Precaution for Brake Control System
Always perform a pre-driving check to drive the vehicle.
Always check speed and safety while driving the vehicle.
To operate CONSULT while driving, more than one person is
required to be in the vehicle to avoid interference
to driving and ensure safety.
Slight vibrations ar ...
