Nissan Sentra Service Manual: U1117 Lost communication (ABS)

Nissan Sentra Service Manual / Transmission & driveline / Transaxle & transmission / CVT: RE0F11A / U1117 Lost communication (ABS)

DTC Logic

DTC DETECTION LOGIC

DTC	CONSULT screen terms [Trouble diagnosis content]	DTC detection condition	Possible causes
U1117	LOST COMM (ABS) [Lost Communication With ABS]	When the ignition switch is ON, TCM is unable to receive the CAN communications signal from ABS actuator and electric unit (control unit) continuously for 2 seconds or more.	ABS actuator and electric unit (control unit) Harness or connector (CAN communication line is open or shorted)

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another вЂњDTC CONFIRMATION PROCEDUREвЂќ occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

Start the engine and wait for 5 seconds or more.
Check the DTC.

Is вЂњU1117вЂќ detected? YES >> Go to TM-159, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

For the diagnosis procedure, refer to LAN-16, "Trouble Diagnosis Flow Chart".

U1000 Can comm circuit

Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excelle ...

P062F Eeprom

DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P062F EEPROM (Internal Control Module EE ...

Other materials:

Using the system
Initialization When the ignition switch is in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. When completed, the system is ready to accept voice commands. If the button is pressed before the initialization completes, the system will announce: “Voice ...

Diagnosis system (bcm) (without intelligent key system)
Common item COMMON ITEM : CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions. Wiper Wiper : consult function (bcm - wiper) DATA MONITOR ACTIVE TES ...

Steering switch (meter control switch) signal circuit
Diagnosis Procedure Regarding wiring diagram information, refer to mwi-28, "wiring diagram". 1.Check combination meter input signal Turn ignition switch on. Measure voltage between the following terminals of the combination meter. Is the inspection result normal? Yes &g ...