Description
If any of the following malfunctions is found for the illumination control switch operation.
Diagnosis procedure
1.Check illumination control switch signal circuit
Check the illumination control switch signal circuit. Refer to mwi-56, "diagnosis procedure".
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace harness or connector.
2.Check illumination control switch
Check the illumination control switch. Refer to mwi-56, "component inspection".
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
Ng >> replace illumination control switch. Refer to mwi-80, "removal and installation".
The steering switch (meter control switch) is inoperative
The oil pressure warning lamp does not turn onDiagnosis system (bcm) (with intelligent key system)
Common item
Common item : consult function (bcm - common item)
Application item
Consult performs the following functions via can communication with bcm.
Direct diagnostic mode
Description
ECU identification
The BCM part number is displayed.
Self diagnostic result
...
1144 Incomplete steering angle sensor adjustment
DTC Logic
Dtc detection logic
Dtc
Display item
Malfunction detected condition
Possible causes
C1144
St ang sen signal
When neutral position adjustment of steering angle
sensor is not complete.
Harness or connector
Steering angle sensor
Abs actu ...
Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat
belt
pre-tensioner"
The supplemental restraint system such as “air bag” and “seat belt pre-tensioner”,
used along
with a front seat belt, helps to reduce the risk or severity of inju ...