Nissan Sentra Service Manual: Symptom diagnosis
Nissan vehicle immobilizer systemnats symptoms
Symptom Table
Note:
- Before performing the diagnosis in the following table, check “SEC-171, "Work Flow"”.
- Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.
- If the following symptoms are detected, check systems shown in the “Diagnosis/service procedure” column in this order.
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
- Mechanical key is not inserted into key cylinder.
| Symptom | Diagnosis/service procedure | Reference page |
| Security indicator does not turn ON or flash. |
|
SEC-190 |
|
GI-39 |
Dtc/circuit diagnosis
Power supply and ground circuit
Diagnosis Procedure
Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description".
Vehicle security indicator
Description
DTC DETECTION LOGIC
NOTE:
U ...
Removal and installation
Nats antenna amp
Removal and installation
REMOVAL
Remove instrument finisher B. Refer to IP-14, "Exploded View".
Using a suitable tool release the pawls on either side and remove the ...
Other materials:
Telescopic operation
Pull the lock lever down 1 and adjust the steering
wheel forward or backward 3 to the desired
position.
Push the lock lever up 1 firmly to lock the
steering wheel in place.
WARNINGDo not adjust the steering wheel any
closer to you than is necessary for proper
steering operation a ...
C1142 Press sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1142
PRESS SEN CIRCUIT
When a malfunction is detected in master cylinder
pressure sensor.
Stop lamp switch system
ABS actuator and electric unit
(co ...
Brake pedal
Inspection
BRAKE PEDAL HEIGHT
Check the brake pedal height (H1) between the dash lower panel (1)
and the brake pedal upper surface.
Brake pedal height (H1) : Refer to BR-54, "Brake Pedal".
CAUTION:
Check the brake pedal height with the floor trim removed.
STOP LAMP SWITCH AND BR ...
