Nissan Sentra Service Manual: Removal and installation
Nats antenna amp
Removal and installation
REMOVAL
- Remove instrument finisher B. Refer to IP-14, "Exploded View".
- Using a suitable tool release the pawls on either side and remove the NATS antenna amp. from the pushbutton ignition switch.
INSTALLATION
Installation is in the reverse order of removal.
Symptom diagnosis
Nissan vehicle immobilizer systemnats
symptoms
Symptom Table
Note:
Before performing the diagnosis in the following table, check
“SEC-171, "Work Flow"”.
Check that vehi ...
Other materials:
Measurement of weights
Secure loose items to prevent weight
shifts that could affect the balance of your
vehicle. When the vehicle is loaded, drive
to a scale and weigh the front and the rear
wheels separately to determine axle
loads. Individual axle loads should not exceed
either of the gross axle weight ratings
( ...
Front grille
Exploded view
Core support cover
Front grille
Emblem
Pawl
Removal and installation
REMOVAL
Remove core support cover bolts (A), clips (B) and core support
cover (1).
Apply protective tape (A) to protect the components from damage.
Remove the front grille ...
P0720 Output speed sensor
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0720
OUTPUT SPEED SENSOR
(Output Speed Sensor Circuit)
The output speed sensor value is less than
150 rpm continuously for 5 seconds ...
