Nissan Sentra Service Manual: Symptom diagnosis
Engine does not start when intelligent key is inside of vehicle
Description
Engine does not start when push-button ignition switch is pressed while carrying intelligent key.
Note:
- Check that vehicle is under the condition shown in “conditions of vehicle” before starting diagnosis, and check each symptom.
- The engine start function, door lock function, power distribution system, and nats-ivis/nvis in the intelligent key system are closely related to each other regarding control. The vehicle security function can operate only when the door lock and power distribution system are operating normally.
Conditions of vehicle (operating conditions)
- Engine start by i-key” setting in “work support” mode of “intelligent key” of “bcm” is on.
- One or more of intelligent keys with registered intelligent key id is in the vehicle.
Diagnosis procedure
1.Perform work support
Perform “inside ant diagnosis” in “work support” mode of “intelligent key” of “bcm” using consult.
Refer to bcs-21, "intelligent key : consult function (bcm - intelligent key)".
>> Go to 2.
2.Perform self-diagnosis result
Select “self diagnostic result” mode of “bcm”, and check whether or not dtc of inside key antenna is detected.
Is dtc detected? Yes >> perform the trouble diagnosis for detected dtc. Refer to bcs-49, "dtc index".
No >> go to 3.
3.Check push-button ignition switch
Check push-button ignition switch.
Refer to sec-78, "component inspection".
Is the operation normal? Yes >> go to 4.
No >> repair or replace malfunctioning parts.
4.Confirm the operation
Confirm the operation again.
Is the inspection normal? Yes >> check intermittent incident. Refer to gi-39, "intermittent incident".
No >> go to 1.
Security indicator lamp does not turn on or blink
Description
Security indicator lamp does not blink when power supply position is other than the on position.
Note:
- Before performing the diagnosis, perform “work flow”. Refer to sec-58, "work flow".
- Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.
Conditions of Vehicle (Operating Conditions)
Power supply position is other than the on position.
Diagnosis procedure
1.Check security indicator lamp
Check security indicator lamp.
Refer to sec-9, "security indicator lamp".
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace the malfunctioning parts.
2.Confirm the operation
Confirm the operation again.
Is the result normal? Yes >> check intermittent incident. Refer to gi-39, "intermittent incident".
No >> go to 1.
DTC/circuit diagnosis
P1610 LOCK MODE
Description
ECM forcibly switches to the mode that inhibits engine start, when engine
start operation is performed 5 times
or more while communication between ECM and BCM is not n ...
Removal and installation
Nats antenna amp
Removal and installation
Removal
Remove instrument finisher b. Refer to ip-14, "exploded view".
Using a suitable tool release the pawls on either side and remove the ...
Other materials:
Service Notice and Precautions for EPS System
Check the following item when performing the trouble
diagnosis.
Check any possible causes by interviewing the symptom and
it′s condition from the customer if any malfunction,
such as EPS warning lamp is turned ON, occurs.
Check if air pressure and size of tires are proper, t ...
Checking bulbs
With all doors closed, apply the parking brake
and place the ignition switch in the ON position
without starting the engine. The following lights
will come on:
If equipped, the following lights come on briefly
and then go off:
If any light fails to come on, it may indicate
an open circuit ...
System
Interior room lamp control system
INTERIOR ROOM LAMP CONTROL SYSTEM : System Diagram
WITH INTELLIGENT KEY
WITHOUT INTELLIGENT KEY
INTERIOR ROOM LAMP CONTROL SYSTEM : System Description
OUTLINE
Interior room lamp* is controlled by the interior room lamp timer
control function of t ...
