Nissan Sentra Service Manual: Removal and installation
Nats antenna amp
Removal and installation
Removal
- Remove instrument finisher b. Refer to ip-14, "exploded view".
- Using a suitable tool release the pawls on either side and remove the NATS antenna amp. from the pushbutton ignition switch.
Installation
Installation is in the reverse order of removal.
Push-button ignition switch
Removal and installation
Removal
- Remove the NATS antenna amp. Refer to SEC-135, "Removal and Installation".
- Using a suitable tool release the pawls and remove the push-button ignition switch from instrument finisher b.
Installation
Installation is in the reverse order of removal.
Symptom diagnosis
Engine does not start when intelligent key is inside of vehicle
Description
Engine does not start when push-button ignition switch is pressed while
carrying intelligent key.
Note:
Check that ...
Other materials:
Changing engine coolant
A NISSAN dealer can change the engine coolant.
The service procedure can be found in the
NISSAN Service Manual.
Improper servicing can result in reduced
heater performance and engine overheating.
WARNING
To avoid the danger of being scalded,
never change the coolant when the ...
P0172 Fuel injection system function
DTC Logic
DTC DETECTION LOGIC
With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture
ratio can be brought closely to the
theoretical mixture ratio based on the mixture ratio feedback signal from the
A/F sensors 1. The ECM calculates
the necessary compensation to correct th ...
Control Units and Electrical Parts
PRECAUTIONS
Never reverse polarity of battery terminals.
Install only parts specified for a vehicle.
Before replacing the control unit, check the input and output and
functions of the component parts.
Do not apply excessive force when disconnecting a connector.
Do not apply exce ...
