Nissan Sentra Service Manual: Strg branch line circuit

Nissan Sentra Service Manual / Electrical & power control / Lan system / Can system (type 3) / Strg branch line circuit

Diagnosis Procedure

1.Check connector

Turn the ignition switch off
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? Yes >> go to 2.

No >> repair the terminal and connector

2.Check harness for open circuit

Disconnect the connector of steering angle sensor.
Check the resistance between the steering angle sensor harness connector terminals.

Is the measurement value within the specification?

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the steering angle sensor branch line.

3.Check power supply and ground circuit

Check the power supply and the ground circuit of the steering angle sensor. Refer to brc-44, "wiring diagram".

Is the inspection result normal? Yes (present error)>>replace the steering angle sensor. Refer to brc-113, "removal and installation".

Yes (past error)>>error was detected in the steering angle sensor branch line.

No >> repair the power supply and the ground circuit.

M&a branch line circuit

Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the combination meter for da ...

AV branch line circuit

Diagnosis procedure 1.Check connector Turn the ignition switch off Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the av control unit for damag ...

Other materials:

Wiring diagram
Meter system Wiring diagram Compass Wiring diagram ...

Both side headlamps (lo) are not turned on
Description The headlamps (both sides) do not turn on in any lighting switch setting. Diagnosis Procedure 1.Check combination switch (lighting and turn signal switch) Check the combination switch (lighting and turn signal switch). Refer to BCS-72, "Symptom Table" (with Intelligent ...

Fuel injector
Component Function Check 1.INSPECTION START Turn ignition switch to START. Is any cylinder ignited? YES >> GO TO 2. NO >> Proceed to EC-450, "Diagnosis Procedure". 2.CHECK FUEL INJECTOR FUNCTION With CONSULT Start engine. Perform вЂњPOWER BALANCEвЂќ in � ...