Nissan Sentra Service Manual: Seat belt warning system

Nissan Sentra Service Manual / Restraints / SRS airbag control system / Symptom diagnosis / Seat belt warning system

Seat Belt Warning System Does Not Function

1.SEAT BELT WARNING LIGHT

Turn ignition switch ON.

Does the seat belt warning lamp come ON? YES >> GO TO 2.

NO >> вЂў Check 10A fuse [No. 8, located in the fuse block (J/B)].

Check seat belt buckle switch (driver seat)
Check harness between combination meter and seat belt buckle switch (driver seat).
Check combination meter. Refer to MWI-25, "Fail-Safe".

2.SEAT BELT BUCKLE (DRIVER SEAT)

Fasten the seat belt buckle (driver seat).

Does the seat belt warning lamp go OFF? YES >> GO TO 3.

NO >> вЂў Check seat belt buckle switch (driver seat).

вЂў Check harness between combination meter and seat belt buckle switch (driver seat).

3.OCCUPANT CLASSIFICATION SYSTEM

Have a helper sit in the passenger seat.

Does the seat belt warning lamp go ON? YES >> GO TO 4.

NO >> вЂў Check occupant classification system. Refer to SRC-12, "OCCUPANT CLASSIFICATION SYSTEM : System Description".

вЂў Check harness between occupant classification control unit and air bag diagnosis sensor unit.

4.SEAT BELT BUCKLE (PASSENGER SEAT)

Fasten the seat belt buckle (passenger seat).

Does the seat belt warning lamp go OFF? YES >> System OK.

NO >> вЂў Check seat belt buckle switch (passenger seat).

вЂў Check harness between seat belt buckle switch (passenger seat) and air bag diagnosis sensor unit.

вЂў Replace air bag diagnosis sensor unit. Refer to SR-28, "Removal and Installation".

SRS Air bag warning lamp does not turn ON

Diagnosis Procedure 1.CHECK COMBINATION METER POWER SUPPLY AND GROUND CIRCUIT Check combination meter unit power supply and ground circuit. Refer to MWI-52, "COMBINATION METER : Diagnosis Pr ...

Ventilation, heater & air conditioner

...

Other materials:

Connector symbols
Most of connector symbols in wiring diagrams are shown from the terminal side. Connector symbols shown from the terminal side are enclosed by a single line and followed by the direction mark. Connector symbols shown from the harness side are enclosed by a double line and followed by the ...

System
System Diagram System Description FRONT WIPER CONTROL (BASIC) BCM detects the combination switch position by the combination switch reading function. BCM transmits the front wiper request signal to the IPDM E/R using CAN communication. IPDM E/R controls the integrated front wipe ...

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Commercial Service Tools Clip list Descriptions for Clips Replace any clips which are damaged during removal or installation. ...