Nissan Sentra Service Manual: Rocker cover

Nissan Sentra Service Manual / Engine / Engine mechanical / Removal and installation / Rocker cover

Exploded View

Oil filler cap
Rocker cover protector
Oil filler tube
O-ring
Rocker cover
Rocker cover gasket

Refer to INSTALLATION

Removal and Installation

REMOVAL

Remove intake manifold. Refer to EM-27, "Exploded View".
Remove rocker cover protector.
Remove ignition coils. Refer to EM-45, "Exploded View".

CAUTION:

Do not drop or shock ignition coil.
Do not disassemble ignition coil.

Move ignition harness aside.
Remove rocker cover.

Loosen bolts in reverse order shown.

Remove PCV valve and PCV hose, if necessary.
Remove rocker cover gasket from rocker cover.

INSTALLATION

CAUTION:

Do not reuse O-rings.

Install the rocker cover gasket to rocker cover.

CAUTION:

Check the gasket is not dropped.

Install rocker cover.

Tighten bolts in two steps separately in numerical order as shown.

Step 1 : 1.96 NВ·m (0.20 kg-m, 17 in-lb)

Step 2 : 8.33 NВ·m (0.85 kg-m, 74 in-lb)

Installation of remaining components is in the reverse order of removal.

INSPECTION AFTER INSTALLATION

Check for engine oil leaks and engine coolant leaks with engine at operating temperature and running at idle.

WARNING:

Do not touch engine immediately after stopping as engine is extremely hot.

Ignition coil

Exploded View Ignition coil Spark plug Rocker cover Removal and Installation REMOVAL Remove the engine room cover. Refer to EM-24, "Exploded View". Disconnect the harne ...

Timing chain

Exploded View Timing chain slack guide Timing chain tensioner Timing chain Oil pump drive chain Crankshaft sprocket Crankshaft key Oil pump sprocket Front cover O-ring O-ring ...

Other materials:

Abs branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the abs actuator and electric unit (control unit) for damage, bend and loose connection (unit side and connector side). ...

Cruise control operations
The cruise control allows driving at a speed between 25 - 89 MPH (40 - 144 km/h) without keeping your foot on the accelerator pedal. To turn on the cruise control, push the ON·OFF switch. The CRUISE indicator light in the instrument panel comes on. To set cruising speed, accelerate the ve ...

Intake manifold
Exploded View Clamp PCV hose Bracket Intake manifold gasket Intake manifold Mount rubber Clamp EVAP hose EVAP canister purge volume control solenoid valve Electric throttle control actuator gasket Electric throttle control actuator Clamp Water hose Water hose ...