Nissan Sentra Service Manual: Removal and installation
Power socket
Removal and installation
Front console power socket
Removal
- Remove the cvt/mt shift selector finisher. Refer to ip-14, "exploded view".
- Remove cap from the front console power socket.
- Remove the screws (a) and the storage bin (1).
- Disconnect the harness connector (a) from the front console power socket (1).
- Release the power socket pawls from the back of the console finisher assembly and remove.
Installation
Installation is in the reverse order of removal.
Console power socket (if equipped)
Removal
- Remove the center console rear finisher. Refer to ip-23, "disassembly and assembly".
- Release the tabs and remove the center console rear finisher cover.
- Disconnect the harness connectors from the power socket and the usb connector (if equipped).
- Release the power socket pawls from the back of the center console rear finisher cover and remove.
Installation
Installation is in the reverse order of removal.
Wiring diagram
Power socket
Wiring Diagram
...
Service data and specifications (SDS)
Power Socket
...
Other materials:
L terminal circuit (short)
Description
The terminal “l” circuit controls the charge warning lamp. The charge warning
lamp turns on when the ignition
switch is set to on or start. When the generator is providing sufficient voltage
with the engine running,
the charge warning lamp turns off. If the charge warni ...
System features
NISSAN Voice Recognition can activate the following
systems:
Bluetoothâ„¢ Hands-Free Phone System
Navigation
Audio
Information
My Apps
For additional information on the navigation system,
see the separate Navigation System Owner’s
Manual.
How to say numbers
NISSAN Voice Rec ...
Multiport fuel injection system
MULTIPORT FUEL INJECTION SYSTEM : System
Description
SYSTEM DIAGRAM
*1: ECM determines the start signal status by the signals of engine speed and
battery voltage.
*2: M/T models
*3: CVT models
*4: This sensor is not used to control the engine system under normal
conditions.
SYSTEM DES ...
