Nissan Sentra Service Manual: Precaution

Nissan Sentra Service Manual / Electrical & power control / Lan system / Can fundamental / Precaution

Precautions for Trouble Diagnosis

Caution:

Follow the instructions listed below. Failure to do this may cause damage to parts:

Never apply 7.0 V or more to the measurement terminal.
Use a tester with open terminal voltage of 7.0 V or less.
Turn the ignition switch off and disconnect the battery cable from the negative terminal when checking the harness.

Precautions for Harness Repair

Solder the repaired area and wrap tape around the soldered area.

Note:

A fray of twisted lines must be within 110 mm (4.33 In).

Bypass connection is never allowed at the repaired area.

Note:

Bypass connection may cause can communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.

Replace the applicable harness as an assembly if error is detected on the shield lines of can communication line.

How to use this manual

Information вЂњCan fundamentalвЂќ of lan section describes the basic knowledge of the can communication system and the method of trouble diagnosis. For information peculiar to a vehic ...

System description

System Can communication system Can communication system : system description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex ...

Other materials:

Door lock
Front door lock Front door lock : exploded view Outside handle bracket Front gasket Outside handle Door lock assembly Door striker Door key cylinder rod Inside handle assembly Outside handle escutcheon Rear gasket Front door lock : removal and installation CAUTION: Befor ...

Both side headlamps do not switch to high beam
Description The headlamps (both sides) do not switch to high beam when the lighting switch is in the hi or pass setting. Diagnosis procedure 1.Combination switch (lighting and turn signal switch) inspection Check the combination switch (lighting and turn signal switch). Refer to bcs-72, &q ...

Eco mode control
ECO MODE CONTROL : System Description SYSTEM DIAGRAM SYSTEM DESCRIPTION ECM receives an ECO mode signal from combination meter via CAN communication and improves the fuel economy by controlling the throttle movement to less than usual. Therefore, driving characteristic is controlle ...