Diagnosis Procedure
1.Check bcm power supply and ground circuit
Check bcm power supply and ground circuit.
Refer to bcs-67, "diagnosis procedure" (with intelligent key) or bcs-120, "diagnosis procedure" (without intelligent key).
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace the malfunctioning parts.
2.Check power window main switch power supply and ground circuit
Check power window main switch power supply and ground circuit.
Refer to PWC-33, "POWER WINDOW MAIN SWITCH : Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace the malfunctioning parts.
3.Replace power window main switch
Is the result normal? Yes >> inspection end
NO >> Check intermittent incident. Refer to GI-39, "Intermittent Incident".
Driver side power window does not operateTurn signal switch
Turn signal
Move the lever up or down to signal the
turning direction. When the turn is completed,
the turn signal cancels automatically.
Lane change signal
To signal a lane change, move the lever up or
down to the point where the indicator light
begins to flash, but the lever ...
Front disc brake
BRAKE PAD
BRAKE PAD : Inspection
PAD WEAR
Check brake pad thickness from an inspection hole on caliper body.
Check using a scale if necessary
Wear limit thickness : Refer to BR-55, "Front Disc
Brake".
DISC ROTOR
DISC ROTOR : Inspection
APPEARANCE
Check surface of disc rotor ...
P0715 Input speed sensor A
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0715
INPUT SPEED SENSOR A
(Input/Turbine Speed Sensor
A Circuit)
The primary speed sensor value is less than
150 r ...