Nissan Sentra Service Manual: Both side front fog lamps are not turned on

Nissan Sentra Service Manual / Driver controls / Exterior lighting system / Symptom diagnosis / Both side front fog lamps are not turned on

Description

The front fog lamps do not turn on in any setting.

Diagnosis procedure

1.Combination switch (lighting and turn signal switch) inspection

Check the combination switch (lighting and turn signal switch). Refer to bcs-72, "symptom table" (with intelligent key system) or bcs-125, "symptom table" (without intelligent key system).

Is the inspection result normal? Yes >> go to 2.

No >> repair or replace the malfunctioning part.

2.Check front fog lamp request signal input

Consult data monitor

Select FR FOG REQ of IPDM E/R DATA MONITOR item.
While operating the front fog lamp switch, check the monitor status.

Is the inspection result normal?

Is the inspection result normal? Yes >> go to 3.

No >> replace bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs- 126, "removal and installation" (without intelligent key system).

3.Front fog lamp circuit inspection

Check the front fog lamp circuit. Refer to EXL-94, "Diagnosis Procedure".

Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-30, "Removal and Installation" (with Intelligent Key system) or PCS-58, "Removal and Installation" (without Intelligent Key system).

NO >> Repair or replace the malfunctioning part.

Parking, license plate and tail lamps are not turned on

Description The parking, license plate and tail lamps do not turn on in with any lighting switch setting. Diagnosis procedure 1.Combination switch (lighting and turn signal switch) inspection Ch ...

Periodic maintenance

...

Other materials:

System
CVT CONTROL SYSTEM CVT CONTROL SYSTEM : System Diagram CVT CONTROL SYSTEM : System Description DESCRIPTION CVT detects the vehicle driving status from switches, sensors and signals, and controls the vehicle so that the optimum shift position and shift timing may always be achieved ...

Abs branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the abs actuator and electric unit (control unit) for damage, bend and loose connection (unit side and connector side). ...

ECO mode switch
ECO mode switch The ECO mode helps to enhance the fuel economy by controlling the throttle sensitivity and transmission points (CVT if so equipped). To turn on the ECO mode, push the ECO mode switch. The ECO mode indicator light (on the speedometer) will remain lit while the mode is act ...