Nissan Sentra Service Manual: P0965 Pressure control solenoid B

Nissan Sentra Service Manual / Transmission & driveline / Transaxle & transmission / CVT: RE0F11A / P0965 Pressure control solenoid B

DTC Logic

DTC DETECTION LOGIC

DTC

CONSULT screen terms (Trouble diagnosis content)

DTC detection condition

Possible causes

P0965

PC SOLENOID B (Pressure control solenoid B control circuit range performance)

The detection conditions continuously for 5 seconds or more under the following diagnosis conditions:

Diagnosis conditions

Selector lever: Other than вЂњPвЂќ and вЂњNвЂќ positions
Auxiliary gearbox shifting is not in progress.
Engine speed: More than 500 rpm

Detection condition A

Actual primary pulley ratio: 2.0 вЂ“ 2.4
Target primary pulley ratio: Less than 1.2

Detection condition B

Actual primary pulley ratio: 0.35 вЂ“ 0.75
Target primary pulley ratio: More than 1.55

Primary pressure solenoid valve

DTC CONFIRMATION PROCEDURE

CAUTION:

Be sure to perform вЂњTM-205, "Diagnosis Procedure"вЂќ and then perform вЂњDTC CONFIRMATION PROCEDUREвЂќ.
Never perform вЂњDTC CONFIRMATION PROCEDUREвЂќ before the repairs. Doing so may result in a secondary malfunction.
Be careful of the driving speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

Start the engine
Drive the vehicle.
Maintain the following conditions for 20 seconds or more.

Vehicle speed : 20 km/h (13 MPH) or more

Stop the vehicle
Check the first trip DTC.

Is вЂњP0965вЂќdetected? YES >> Go to TM-205, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK INTERMITTENT INCIDENT

Refer to GI-39, "Intermittent Incident".

Is the inspection result normal? YES >> Replace transaxle assembly. Refer to TM-283, "Removal and Installation".

NO >> Repair or replace malfunctioning parts.

P0963 Pressure control solenoid A

DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0963 PC SOLENOID A (Pressure Control So ...

P0966 Pressure control solenoid B

DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0966 PC SOLENOID B (Pressure Control So ...

Other materials:

P0171 Fuel injection system function
DTC Logic DTC DETECTION LOGIC With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture ratio can be brought closely to the theoretical mixture ratio based on the mixture ratio feedback signal from the A/F sensors 1. The ECM calculates the necessary compensation to correct th ...

Installing front license plate
Use the following steps to mount the front license plate: Make holes on the plastic finisher at the location mark (small dimple) using a 0.20 in (5 mm) drill. Apply light pressure to the drill. Install the license plate holder using the two screws provided with the holder. Mount ...

How to select piston and bearing
Description Selection points Selection parts Selection items Selection methods Between cylinder block and crankshaft Main bearing Main bearing grade (bearing thickness) Determined by match of cylinder block bearing housing grade (inner diameter of hous ...