Nissan Sentra manuals

Nissan Sentra Service Manual: Od off indicator lamp

Nissan Sentra Service Manual / Transmission & driveline / Transaxle & transmission / CVT: RE0F11A / Od off indicator lamp

Component Function Check

1.CHECK OD OFF INDICATOR LAMP FUNCTION

Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON.

Is the inspection result normal? YES >> INSPECTION END

NO >> Go to TM-239, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC (TCM)

With CONSULT


  1. Turn ignition switch ON.
  2. Check “Self Diagnostic Results” in “TRANSMISSION”.

Is any DTC detected? YES >> Check DTC detected item. Refer to TM-126, "DTC Index".

NO >> GO TO 2.

2.CHECK DTC (COMBINATION METER)

Check “Self Diagnostic Results” in “METER/M&A”. With CONSULT


Check “Self Diagnostic Results” in “METER/M&A”.

Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-26, "DTC Index".

NO >> GO TO 3.

3.CHECK COMBINATION METER INPUT SIGNAL

With CONSULT


  1. Shift the selector lever to “D” position.
  2. Select “Data Monitor” in “METER/M&A”.
  3. Select “O/D OFF IND”.
  4. Check that “O/D OFF IND” turns ON/OFF when overdrive control switch is operated. Refer to MWI-20, "Reference Value".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

NO >> GO TO 4.

4.CHECK TCM INPUT/OUTPUT SIGNAL

With CONSULT


  1. Select “Data Monitor” in “TRANSMISSION”.
  2. Select “SPORT MODE SW”.
  3. Check that “SPORT MODE SW” turns ON/OFF when overdrive control switch is operated. Refer to TM- 114, "Reference Value".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

NO >> Check overdrive control switch circuit. Refer to TM-236, "Diagnosis Procedure".

Overdrive control switch
Component Function Check 1.CHECK SPORT INDICATOR LAMP FUNCTION Check OD OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection result normal? YES &g ...

Shift position indicator circuit
Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR Start the engine. Shift selector lever. Check that the selector lever position and the shift position indicator on the ...

Other materials:

Difference between predicted and actual distances
The distance guide line and the vehicle width guide line should be used as a reference only when the vehicle is on a level, paved surface. The distance viewed on the monitor is for reference only and may be different than the actual distance between the vehicle and displayed objects. Backing u ...

Driving on snow or ice
WARNING Wet ice (32°F, 0°C and freezing rain), very cold snow or ice can be slick and very hard to drive on. The vehicle will have much less traction or “grip” under these conditions. Try to avoid driving on wet ice until the road is salted or sanded. Wha ...

Strg branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side). Is the inspection result ...

© 2014-2026 Copyright b17.nisentra.com