Nissan Sentra Service Manual: Mixture ratio self-learning value clear
Description
This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”.
Work Procedure
1.START
With CONSULT
- Start engine and warm it up to normal operating temperature.
- Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.
- Clear mixture ratio self-learning value by touching “CLEAR”.
With GST
- Start engine and warm it up to normal operating temperature.
- Turn ignition switch OFF.
- Disconnect mass air flow sensor harness connector.
- Restart engine and let it idle for at least 5 seconds.
- Stop engine and reconnect mass air flow sensor harness connector.
- Select Service $03 with GST. Make sure DTC P0102 is detected.
- Select Service $04 with GST to erase the DTC P0102.
>> END
Idle air volume learning
Description
Idle Air Volume Learning is a function of ECM to learn the idle air volume
that keeps each engine idle speed
within the specific range. It must be performed under any of the following ...
Fuel pressure
Work Procedure
FUEL PRESSURE RELEASE
1.FUEL PRESSURE RELEASE
With CONSULT
Turn ignition switch ON.
Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINEР...
Other materials:
Flywheel
Exploded View
Flywheel
Removal and Installation
REMOVAL
Remove the engine and the transaxle assembly from the vehicle, and
separate the transaxle from the
engine. Refer to TM-28, "Exploded View".
Remove flywheel.
Secure flywheel (1) using Tool (A), and remove b ...
Component parts
Component Parts Location
ABS actuator and electric unit (control
unit)
IPDM E/R
Brake fluid level switch
Front wheel sensor LH (RH similar)
Rear wheel sensor LH (RH similar)
VDC OFF switch
Steering angle sensor
(view with steering wheel removed)
Sto ...
Anti-lock Braking System (ABS)
WARNING
The Anti-lock Braking System (ABS) is a
sophisticated device, but it cannot prevent
accidents resulting from careless
or dangerous driving techniques. It can
help maintain vehicle control during
braking on slippery surfaces. Remember
that stopping distances ...
