Nissan Sentra Owners Manual: Seat belt maintenance

Nissan Sentra Owners Manual / Safety—Seats, seat belts and supplemental restraint system / Seat belts / Seat belt maintenance

To clean the seat belt webbing, apply a mild soap solution or any solution recommended for cleaning upholstery or carpet.
Then wipe with a cloth and allow the seat belts to dry in the shade. Do not allow the seat belts to retract until they are completely dry.
If dirt builds up in the shoulder belt guide of the seat belt anchors, the seat belts may retract slowly. Wipe the shoulder belt guide with a clean, dry cloth.
Periodically check to see that the seat belt and the metal components, such as buckles, tongues, retractors, flexible wires and anchors, work properly. If loose parts, deterioration, cuts or other damage on the webbing is found, the entire seat belt assembly should be replaced.

Seat belt extenders

If, because of body size or driving position, it is not possible to properly fit the lap/shoulder belt and fasten it, an extender that is compatible with the installed seat belts is available that ...

Child safety

WARNINGDo not allow children to play with the seat belts. Most seating positions are equipped with Automatic Locking Retractor (ALR) mode seat belts. If the seat belt becomes wr ...

Other materials:

Power supply and ground circuit
WITH INTELLIGENT KEY SYSTEM WITH INTELLIGENT KEY SYSTEM : Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS-51, "Wiring Diagram". 1.Check fuses and fusible link Check that the following fuses and fusible link are not blown. Is the fuse blown? Yes >> r ...

P060A ECM
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P060A CONTROL MODULE (Internal control module monitoring processor performance) ECM internal monitoring processor is malfunctioning. ...

Eps branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the eps control unit for damage, bend and loose connection (unit side and connector side). Is the inspection result norm ...