Nissan Sentra Service Manual: Low tire pressure warning lamp blinks
Diagnosis Procedure
NOTE:
If low tire pressure warning lamp repeats blinking ON for 2 seconds and OFF for 0.2 seconds, wake-up operation for all transmitters is not complete.
Carry out transmitter wake-up operation. Refer to WT-22, "Work Procedure".
1.CHECK BCM CONNECTOR
- Turn ignition switch OFF.
- Disconnect BCM connectors.
- Check terminals for damage or loose connections.
Is the inspection result normal? YES >> Replace BCM. Refer to BCS-73, "Removal and Installation" (with Intelligent Key system) or BCS- 126, "Removal and Installation" (without Intelligent Key system).
NO >> Repair or replace damaged parts.
Low tire pressure warning lamp does not turn oFF
Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.INSPECT BCM CONNECTOR
Turn ignition switch OFF.
Disconnect BCM connectors.
Check terminals fo ...
Easy fill tire alert does not activate
Description
The Easy Fill Tire Alert does not function while inflating a tire when the
select lever position is in P-range with
the ignition switch ON. Refer to WT-8, "TIRE PRESSURE MONITORIN ...
Other materials:
Unit disassembly and assembly
Steering gear and linkage
Exploded View
Outer socket
Boot clamp (small diameter)
Boot
Boot clamp (large diameter)
Inner socket
Gear housing assembly
Disassembly and Assembly
DISASSEMBLY
Loosen outer socket lock nut, and remove outer socket.
CAUT ...
Power window and door lock/unlock switch RH
Removal and Installation
REMOVAL
Release the pawls using a suitable tool and lift the power window and
door lock/unlock switch RH and finisher
as an assembly and remove.
Disconnect the harness connector from the power window and door
lock/unlock switch RH.
Release the four pawls (tw ...
AV branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the av control unit for damage,
bend and loose connection (unit
side and connector side).
Is the inspection result normal ...
