Nissan Sentra Service Manual: Illumination control switch
Removal and installation
Removal
- Remove instrument finisher d. Refer to ip-14, "exploded view".
- Remove the illumination control switch (1) from the switch carrier (2) using suitable tool (a).
: Pawl
Installation
Installation is in the reverse order of removal.
Trunk room lamp
Removal and Installation
Warning:
Do not touch bulb while it is lit or right after being turned off.
Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow ...
Service data and specifications (SDS)
Bulb Specifications
*: Always check with the parts department for the latest parts information. ...
Other materials:
Heating and cooling unit assembly
Exploded view
With air conditioning
Defroster seal
Center ventilator seal
Upper distribution module
Side ventilator seal (LH)
Blower motor
Blower unit
Intake door motor
Power transistor
Power transistor wiring harness
Front floor duct (lh)
Vent and defroster linkage
Mo ...
DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT
Description
CAN (Controller Area Network) is a serial communication system for real time
application. It is an on-vehicle
multiplex communication system with high data communication speed and excellent
error detection ability.
Many electronic control units are equip ...
Rear suspension beam
Exploded View
Rear suspension beam
Rear suspension arm bracket
Front
Removal and Installation
NOTE:
When removing components such as hoses, tubes, lines, etc., cap or plug
openings to prevent fluid from spilling.
REMOVAL
Remove the rear wheels and tires using power tool. Ref ...
