Nissan Sentra Service Manual: Seat belt buckle switch signal circuit
Description
Transmits a seat belt buckle switch lh (driver seat) signal to the combination meter
Component function check
1. Check combination meter input signal
Select data monitor for meter/m&a and check the buckle sw monitor value.
YES >> Inspection End.
NO >> Refer to WCS-29, "Diagnosis Procedure".
Diagnosis procedure
Regarding wiring diagram information, refer to wcs-17, "wiring diagram".
1.Check combination meter input signal
- Turn ignition switch on.
- Check voltage between combination meter harness connector m24 terminal 9 and ground.
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> go to 2.
2.Check seat belt buckle switch circuit
- Turn ignition switch OFF.
- Disconnect combination meter harness connector m24 and seat belt buckle switch lh (driver seat) harness connector b16.
- Check continuity between combination meter harness connector m24 terminal 9 and seat belt buckle switch lh (driver seat) harness connector b16 terminal 1.
- Check continuity between combination meter harness connector m24 terminal 9 and ground.
Is the inspection result normal?
Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check seat belt buckle switch ground circuit
Check continuity between seat belt buckle switch lh (driver seat) harness connector b16 terminal 2 and ground.
Is the inspection result normal? Yes >> check the seat belt buckle switch. Refer to wcs-30, "component inspection".
No >> repair or replace harness or connector.
Component inspection
1. Check seat belt buckle switch
- Turn ignition switch off.
- Disconnect the seat belt buckle switch lh (driver seat).
- Check continuity between the seat belt buckle switch lh (driver seat) terminals 1 and 2.
Is the inspection result normal? Yes >> inspection end.
No >> replace the seat belt buckle switch lh (driver seat). Refer to sr-32, "removal and installation".
Meter buzzer circuit
Description
The buzzer for warning chime system is installed in the combination
meter.
The combination meter sounds the alarm buzzer based on the signals
transmitted from various units.
...
Other materials:
How to use this manual
How to use this section
Information
“Can” of lan section describes information peculiar to a vehicle and
inspection procedures.
For trouble diagnosis procedure, refer to lan-16, "trouble diagnosis
flow chart" of “can fundamental”.
Abbreviation list
Unit ...
P0746 Pressure control solenoid A
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0746
PRESSURE CONTROL SOLENOID
A
(Pressure Control Solenoid A
Performance/Stuck Off)
The detecting condition A or detection conditi ...
Vehicle Dynamic Control (VDC) system
The Vehicle Dynamic Control (VDC) system uses
various sensors to monitor driver inputs and vehicle
motion. Under certain driving conditions,
the VDC System helps to perform the following
functions:
Controls brake pressure to reduce wheel
slip on one slipping drive wheel so power is
trans ...
