Nissan Sentra manuals

Nissan Sentra Service Manual: Front power window motor

Removal and Installation

REMOVAL

  1. Remove the front door glass regulator (2). Refer to GW-16, "Removal and Installation".
  2. Remove the bolts (A) and the front power window motor (1).

INSTALLATION


INSTALLATION

Installation is in the reverse order of removal.

Front regulator
Exploded View Front door panel Front door glass channel front Front door glass regulator Front door glass regulator motor Front door glass channel rear Front door glass Front door ...

Rear door glass
Removal and Installation REMOVAL NOTE: LH rear door panel shown; RH similar. Remove the rear door finisher. Refer to INT-19, "Removal and Installation". Remove the vapor barrier. ...

Other materials:

C1121, C1123, C1125, C1127 ABS OUT Valve system
DTC Logic DTC DETECTION LOGIC DTC DETECTION LOGIC Display Item Malfunction detected condition Possible causes C1121 FR LH OUT ABS SOL When a malfunction is detected in front LH ABS OUT valve. Harness or connector ABS actuator and electric unit ...

Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...

Does not stop fully-open or fullyclosed position
Diagnosis procedure 1. Perform initialization procedure Perform initialization procedure. Refer to RF-18, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> Inspection End. NO >> Perform basic ins ...

В© 2014-2026 Copyright b17.nisentra.com