Nissan Sentra manuals

Nissan Sentra Owners Manual: Exhaust gas (carbon monoxide)

WARNING

Do not breathe exhaust gases; they contain colorless and odorless carbon monoxide. Carbon monoxide is dangerous.

It can cause unconsciousness or death.

  • If you suspect that exhaust fumes are entering the vehicle, drive with all windows fully open, and have the vehicle inspected immediately.

  • Do not run the engine in closed spaces such as a garage.

  • Do not park the vehicle with the engine running for any extended length of time.

  • Keep the rear vent windows, lift gates, doors and trunk lids (if so equipped) closed while driving, otherwise exhaust gases could be drawn into the passenger compartment. If you must drive with one of these open, follow these precautions:

  1. Open all the windows.

  2. Set the recirculation button air
    recirculation button to off and the fan control dial to high to circulate the air.

  • If electrical wiring or other cable connections must pass to a trailer through the seal on the trunk lid or the body, follow the manufacturer’s recommendation to prevent carbon monoxide entry into the vehicle.

  • The exhaust system and body should be inspected by a qualified mechanic whenever:

  1. The vehicle is raised for service.

  2. You suspect that exhaust fumes are entering into the passenger compartment.

  3. You notice a change in the sound of the exhaust system.

  4. You have had an accident involving damage to the exhaust system, underbody, or rear of the vehicle.

Precautions when starting and driving
WARNING Do not leave children or adults who would normally require the assistance of others alone in your vehicle. Pets should also not be left alone. They could accidentall ...

Three-way catalyst
The three-way catalyst is an emission control device installed in the exhaust system. Exhaust gases in the three-way catalyst are burned at high temperatures to help reduce pollutants. WARN ...

Other materials:

Service
Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual. Before servicing the SRS, turn power switch OFF, disconnect battery negative terminal and wait 3 minutes or more. For approximately 3 minutes after the cables are removed, it is stil ...

Turn signal lamp circuit
Description The bcm monitors inputs from the combination switch to determine when to activate the turn signals. The bcm outputs voltage direction to the left and right turn signals during turn signal operation or both during hazard warning operation. The bcm sends a turn signal indicator req ...

Cooler pipe and hose
Exploded view High-pressure service port High-pressure pipe Expansion valve Low-pressure service port Low-pressure flexible hose Compressor Refrigerant pressure sensor Condenser and liquid tank assembly High-pressure flexible hose Low-pressure flexible hose Low-pressure f ...

© 2014-2026 Copyright b17.nisentra.com