Nissan Sentra manuals

Nissan Sentra Owners Manual: Engine cooling system

The engine cooling system is filled at the factory with a pre-diluted mixture of 50% Genuine NISSAN Long Life Antifreeze/Coolant (blue) and 50% water to provide year-round anti-freeze and coolant protection. The antifreeze solution contains rust and corrosion inhibitors. Additional engine cooling system additives are not necessary.

WARNING

  • Never remove the radiator or coolant reservoir cap when the engine is hot.

    Wait until the engine and radiator cool down. Serious burns could be caused by high pressure fluid escaping from the radiator. See precautions in “If your vehicle overheats” found in the “In case of emergency” section of this manual.

  • The radiator is equipped with a pressure type radiator cap. To prevent engine damage, use only a genuine NISSAN radiator cap

CAUTION

Engine compartment check locations
MRA8DE engine Engine oil filler cap Brake and clutch (if so equipped) fluid reservoir Air cleaner Battery Fuse/fusible link box Engine coolant reservoir Radiator cap Engine oil ...

Checking engine coolant level
Check the coolant level in the reservoir when the engine is cold. If the coolant level is below the MIN level B , add coolant to the MAX level A . If the reservoir is empty, check the coolant ...

Other materials:

Low tire pressure warning lamp does not turn on
Low Tire pessure Warning Lamp Does Not Come On When Ignition Switch Is Turned On Note: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS transmitter IDs Display t ...

Thermostat and thermostat housing
Exploded View Thermostat housing Gasket Rubber ring Thermostat Water inlet Clamp Radiator hose (upper) To radiator WARNING: Do not remove the radiator cap when the engine is hot. Serious burns could occur from high-pressure engine coolant escaping from the radiator. ...

Dtc/circuit diagnosis
Power supply and ground circuit Audio unit AUDIO UNIT : Diagnosis Procedure Regarding wiring diagram information, refer to av-88, "wiring diagram". 1.Check fuse Check that the following fuses are not blown. Are the fuses blown? Yes >> replace the blown fuse after repairing ...

© 2014-2026 Copyright b17.nisentra.com